6.0 / 4L60E LS Swap GM 0411 PCM ECM Computer W/ VATS Deleted DBC Cable

Description

This listing is for BOTH the PCM / ECM Computer and the Programming.
The computer model number is
Delphi # 12200411 (Red/Blue connectors)
The GM Gen 3 computer will arrive ready for your LS swap or stock application.
The Tune is for a stock
1999-2002
6.0L / 4L60E
drive train. It is for the
DBC / Drive by Cable - Mechanical throttle body
. This will work for the
99-02 Mechanical Throttle Body
engines.
I only sell units with a "Stock Tune" to prevent damage to your engine.
The Following changes have been made to the program:
- VATS Disabled
- Speed Limiters set to Maximum
- Power Enrichment is Active
- Dual electric fans Enabled
- Fan 1: On@195   Off@185
- Fan 2: On@ 215  Off@205
The engine electrical connections needed are :
- Mass Air Flow Sensor (5 wire)
- Manifold Pressure Sensor
- Fuel Injectors
- Idle Air Control motor
- Throttle Position Sensor
- Crank and cam sensors
- Coil Packs
- Engine Temperature Sensor
- Front O2 Sensors
All other stock connections are not required such as Alternator codes, Fuel level code, and Fuel pump codes, etc..
If you'd like to use the speedometer output from the computer, include a "Note to Seller" when purchasing that includes your rear axle ratio and your rear tire size or rear tire diameter in inches. The speedometer output isn't necessary for the computer to operate the engine, it's only necessary for the correct speedometer reading.